Starter Fertilizer Crop Safety with In-Furrow and Band Applications

By GROWMARK, Inc.

  • Starter fertilizers are used to increase initial seedling growth and establishment.
  • Fertilizers with high salt indexes can cause death of seedlings or subsequent desiccation if applied inappropriately
  • Ammonia burn can also injure seedlings if applied incorrectly

Figure 1. Burnt radicle due to salt injury. Photo from UNL Extension.

With planting soon to start, you may have questions about starter fertilizer applications for both corn and soybeans. Starter fertilizer is defined as small amounts of nutrients placed in a concentrated zone near the seeds at planting. The goal of a starter fertilizer is to provide easily accessible nutrients for crop growth during the initial phases of growth, thereby improving establishment. This article will review factors to consider when placing nutrients in-furrow or 2 x 2.

Regardless of total soil fertility, an in-furrow “pop-up” or 2 x 2 starter fertilizer can be especially beneficial when the crop is planted into colder, wet soils. This type of “early soil” environment is conducive to sluggish conditions which adversely affect nutrient mineralization, nutrient mobility and early root growth & development. It’s also important to remember that soil in no-till and reduced tillage systems will typically be colder and wetter than those in conventional tillage systems.

The fertilizer salt index is a measure of the salt concentration induced in a soil solution. It does not predict the exact amount of fertilizer material / formulation that could produce crop injury under specific soil conditions, but it does enable comparisons of formulations for their potential salt effects. The salt index is a numeric ratio of the increase in osmotic pressure produced by a selected fertilizer product compared to that produced by the same weight of sodium nitrate (NaNO3), where sodium nitrate is assigned a relative value of 100. The higher the salt index value, the greater potential for salt related injury to the crop. Examples of different fertilizer materials and their salt index values can be found in Table 1.

Salt injury can occur when the salt is near the germinating seed or to growing plant tissue. The presence of the salt creates an osmotic imbalance in which water flows from regions of lower relative salt concentration in the plant tissue to regions of higher relative salt concentration where the fertilizer is in the soil. This loss of water from the plant tissue causes desiccation injury, often referred to as fertilizer burn.

An additional potential crop injury risk that can occur is free ammonia burn. This ammonia burn should not be confused with anhydrous ammonia burn. Fertilizer sources such as urea, UAN, ammonium thiosulfate, and DAP can liberate ammonia and burn seed or plant tissue. Use of these fertilizer sources on the seed or in a 2 x 2 placement results in release of ammonia when these sources are applied to soils. Use of these sources of nutrients on the seed should be avoided, while the use of a 2 x 2 configuration should be limited to rates reflecting only early season crop needs. Failure to follow these guidelines may result in significant crop injury. Other sources of fertilizer such as MAP, ammonium sulfate and ammonium nitrate do not release ammonia as easily and are of lesser concern, but not completely absolved of this type of injury.

As a rule of thumb, you should not apply more than 10 lbs/acre of N + K2O products alone or in combination as a seed furrow application. In addition, products with salt indices greater than 20 should not be used. While a 2 x 2 planter application allows for higher rates of application beyond early season crop needs, there are limitations on the amount of fertilizer that can be banded. These limitations are dependent or based on soil texture, CEC, and soil pH. Coarse soil textures (sandy soils) have greater pore space, allowing increased movement of concentrated liquified forms and liberated ammonia away from the band. Lower CEC soils (CEC ≤ 12) have fewer exchange sites to which ammonium and potassium ions can attach, leaving them mobile in the soil.

Regardless of the soil pH prior to application, ammonia volatilization and plant injury can occur under higher rates of free ammonia liberating fertilizers such as Urea, ATS, UAN, and DAP. Open pore spaces can provide a pathway to the young roots or seed to gases and salt solutions. Any plant roots that grow toward concentrated bands of fertilizer can become burned, which can affect the root’s ability to take up nutrients. If cool wet conditions exist, prolonged contact with fertilizer bands can result in salt injury or ammonia burn.

Crop injury from salt and/or liberation of free ammonia are of less concern under normal rates of fertilizer except under these conditions:

  • In-furrow (pop-up) on-the-seed and 2×2 placement of fertilizer
    • High salt index fertilizers are applied
    • Higher than early season crop needs of fertilizer are applied
    • Soils are dry, preventing normal dilution of product through the soil and allowing high concentrations to remain near seed.
    • Weather conditions are hot and dry.
    • Soil pH is >6.8 resulting in liberation of ammonia. The higher the rate applied, the greater the risk
    • Urea, ammonium thiosulfate or DAP are used as a high percentage of total analysis applied in a 2 x 2 band. DO NOT APPLY THESE SOURCES IN-FURROW.
    • Maladjusted or ill-maintained starter equipment that results in placement of fertilizer closer than 2″

Using certain micronutrients with starter fertilizers can negatively impact crop establishment. For example, applying boron directly on the seed can significantly decrease germination. With all other secondary nutrients and micronutrients, add small quantities to the mix to ensure that no antagonisms occur. Antagonisms can be related to the formation of unwanted compounds or competition with macronutrients for plant uptake.

Whether using an in-furrow or a 2 x 2 starter application, moderation of the rate applied goes a long way in mitigating the risk of injury to the seed or plant.

For assistance on starter fertilizer rates and the potential adverse effects on the crop as an in-furrow or a 2 x 2 application, contact your EverGRO FS Crop Specialist.

References:

Understanding Salt Index of Fertilizers by Carrie A.M. Laboski of the University of Wisconsin-MadisonNebGuide G316 from University of Nebraska Extension.

Starter phosphorous fertilizer and additives in North Carolina Soils: Use, placement, and plant response

Leave a Reply

Your email address will not be published. Required fields are marked *

You May Also Like

ContactUs

Have any questions or inquiries regarding our products, services, or locations? Leave us a quick message and let us know.